September 17, 2016|
Part 1 can be found here : https://www.youtube.com/watch?v=8feZYk9HmYg
In Part 2 of this Mini NES build guide, YouTuber daftmike takes a look on how to put the necessary components and the Rasberry Pi together inside the 3D Printed case in order to replicate the outer look of the original NES! Make sure to check out his video down below, as well as his Twitter, and let us know what you think!
If you would like to recommend any content to be featured on Source Gaming, you can let us know on our Twitter page or in the comments section below!
Latest posts by SG (see all)
- SG Roundtable: Open-Worlds or Multiple, Controlled, Choices (patreon request) - November 23, 2023
- SG Roundtable – Our favourite “Metroidvanias” (Patreon Request) - October 7, 2023
- SG Roundtable: Our favourite “Nintendo-likes” (Patreon Request) - August 15, 2023